MIL-M-80269
The machining center may contain reclaimed
Reclaimed materials.
3.2.2
materials provided such materials will not jeopardize the machine's intended
The reclaimed materials shall have been reprocessed,
use and performance.
remanufactured, or recycled in a manner which will restore them to the same
chemical composition and physical properties as the materials originally
selected for use on the machine.
The machining center and its components that
3.2.3 Energy efficiency.
directly consume energy in normal operation shall be designed and con-
structed for energy efficiency as governed by the developments available
within the industry.
All operating controls shall be located convenient to
3.2.4 Controls.
the operator at his normal work station.
Safety and health requirements.
Covers, guards, or other safety
3.2.5
devices shall be provided for all parts of the machine that present safety
The safety devices shall not interfere with the operation of the
hazards.
The safety devices shall prevent unintentional contact with the
machine.
guarded part, and shall be removable to facilitate inspection, maintenance,
All machine parts, components, mechanisms, and
and repair of the parts.
assemblies furnished on the machine, whether or not specifically required
herein, shall comply with all of the requirements of 29 CFR 1910 that are
In addition, the machine shall comply
applicable to the machine itself.
with all requirements of ANSI B11.8 that are designated therein as the
In the event of conflict
responsibility of the machine manufacturer.
between the requirements of OSHA and the ANSI standards, the requirements of
Additional safety and health requirements shall be as
OSHA shall apply.
specified (see 6.2.1).
The machine shall not contain mercury or
Mercury restriction.
3.2.6
mercury compounds nor be exposed to free mercury during manufacture.
Asbestos and materials containing asbestos
3.2.7 Asbestos restriction.
shall not be used on or in the machine.
The machine shall be so designed and
Environmental protection.
3.2.8
constructed that under the operating, service, transportation, and storage
conditions described herein, the machine shall not emit materials hazardous
to the ecological system as prescribed by Federal, state, or local statutes
in effect at point of installation.
3.2.9 Lubrication. An automatic lubricating system shall be provided for
all parts and mechanisms requiring a continuous flow of lubricating oil.
Means for determining oil level in each reservoir shall be by oil level
sight gauge, a low oil level warning light, or a similar device. Mechanisms
requiring periodic manual lubrication shall be readily accessible for ser-
vicing. Each recirculating system shall include a cleanable or replaceable
filter.
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business